HomeLamp/.pio/libdeps/pico/MyLD2410

MyLD2410 Arduino library

Introduction

This library covers the complete set of serial commands for the HLK-LD2410x presence sensor. It has no external dependencies and will work on any Arduino and ESP32 board.

HLK-LD2410C

HLK-LD2410

Installation

1. It is recommended to install this library from the Arduino Library Manager (search for "MyLD2410"). However, if the Arduino Library Manager does not find it, or you prefer to install it yourself, download or clone this repository.

   • Unzip the downloaded archive in the Arduino/libraries folder.

   • Restart the Arduino IDE.

2. Include the header file: #include <MyLD2410.h> in your sketch.

Usage

• Decide which hardware serial stream you'll be using for communication. For 5V Arduino boards you must use a voltage divider (1:2 or 2:3) on the TX line to protect the RX pin of the sensor, which operates at 3.3V.
  

#define sensorSerial Serial1

Board	Serial	RX pin	Tx pin
ESP32 WROOM-32	Serial1	16	17
ESP32-S3 WROOM	Serial1	18	17
Xiao-ESP32-c3	Serial0	D7	D6
Xiao-ESP32-c6	Serial0	D7	D6
Adruino Nano 33 IoT	Serial1	D1	D0
Adruino Pro-Micro (Leonardo)	Serial1	D0	D1

• Create a global instance of the sensor object

MyLD2410 sensor(sensorSerial);

• In the setup() function, begin serial communication with baud rate LD2420_BAUD_RATE (256000). On ESP32-WROOM: RX_PIN(16), TX_PIN(17). Check the exact pin numbers for your board. Then call sensor.begin() to begin communication with the sensor.

  sensorSerial.begin(LD2410_BAUD_RATE, SERIAL_8N1, RX_PIN, TX_PIN);
  if (!sensor.begin()) {
  Serial.println("Failed to communicate with the sensor");
  while (true);
  }
  

• In the loop() function, call as often as possible sensor.check(). This function returns:

  1. MyLD2410::DATA if a data frame is received

  2. MyLD2410::ACK if a command-response frame is received

  3. MyLD2410::FAIL if no useful information was processed

• Use the many convenience functions to extract/modify the sensor data (see the examples below).

Examples

• Once the library is installed, navigate to: File->Examples->MyLD2410 to play with the examples. They are automatically configured for some popular boards (see the table above). For other boards, minor (trivial) modifications may be necessary.

  1. sensor_data - retrieves all data frames from the sensor and outputs useful information every second. Handles both basic and enhanced (engineering) modes.

  2. print_parameters- prints the current device parameters.

  3. modify_parameters - demonstrates how to modify various sensor parameters. At the end, the original state of the sensor is restored.

  4. factory_reset - restores the factory default values of the sensor parameters.

  5. set_bt_password - sets a new Bluetooth password, or resets the password to its default value "HiLink". Be careful not to get locked out of your sensor.

     • The password must be 6 characters long. If you enter a longer password (on line 54), it will be truncated to 6 characters.

     • If you provide a shorter one, it will be padded with spaces (0x20).

     • To restore the default password, uncomment the line #define RESET_PASSWORD and flash the sketch again.

  6. set_baud_rate - sets and tests a new baud rate for communication with the sensor. Be careful not to get locked out of your sensor.